Şimdi Ara

Wrt610n hakkında acil yardim

Daha Fazla
Bu Konudaki Kullanıcılar: Daha Az
1 Misafir - 1 Masaüstü
5 sn
4
Cevap
0
Favori
657
Tıklama
Daha Fazla
İstatistik
  • Konu İstatistikleri Yükleniyor
0 oy
Öne Çıkar
Sayfa: 1
Giriş
Mesaj
  • Merhabalar
    Wrt610n e ddwrt fw yükledim. 610 a 192.168.1.2 ip sinı verdim router uçtu hard reset yaptım 30/30/30 reset yaptım router açılmıyor nasıl geri dondurebilirim yardımcı olurmusunuz lütfen acil
    Teşekkürler



  • Ilk basta DHCP acik olmadigi icin bilgisayarinizada el ile IP vermeniz gerekmekte.
  • Hocam elle ip verdim yine makine cevap vermiyor
  • http://www.dd-wrt.com/wiki/index.php/Linksys_WRT610N

    Recovery (Unbricking)

    A simple way to recover a bricked device (confirmed to work with both CFE.12 and CFE.16) is:

    unplug all ethernet ports (Important!)
    unplug power
    plug power in
    wait 2-2.5 seconds
    press the reset button and keep it pressed for 5 seconds, then release it
    reconnect ethernet (DHCP shoud give IP address to computer)
    point your browser at 192.168.1.1. You should see a "Management Firmware update" screen where you can flash the original firmware or dd-wrt directly (even mega builds).

    Alternative Method 1:

    manually assign 192.168.1.10 to your computer
    unplug power
    plug power in
    wait 0.5-1.0 seconds
    press the reset button and keep it pressed for 1 second, then release it
    point your browser at 192.168.1.1.

    Alternative Method 2:

    manually assign 192.168.1.10 to your computer
    unplug power
    plug power in
    wait for all lights blink
    press the reset button and keep it pressed for 1 second or 3/4 flashes of the power-light, then release it
    point your browser at 192.168.1.1.

    The alternative methods are reported to work well on the wrt-610Nv1 CTGxxxx series (mostly works at the first attempt); these series are using CFE .16

    On occasion, the recovery method will not accept a new dd-wrt image. Download the latest official WRT610N firmware from linksys and flash it back to the router via recovery method. Once the router is back online and you can navigate to the web gui, reflash dd-wrt to the router.

    The management mode can also be activated from the serial console using

    nvram set safe_mode_upgrade=on
    nvram commit
    reboot




  • 
Sayfa: 1
- x
Bildirim
mesajınız kopyalandı (ctrl+v) yapıştırmak istediğiniz yere yapıştırabilirsiniz.