SLA Printer için fikir verin lütfen

Arkadaşlar elimde kardeşimin yurtdışına gitmeden gümrük mağzasından yedekleri ile aldığı bir

Facture draken marka harici ışık ( dlp projektör ) ile çalışan ama arızalı bir yazıcı var. Elimden çıkarmak istiyorum lakin

Yaptırıp mı elden çıkarmak , yoksa bu şekilde proje olarak satmak mümkün mü? İşi bilen fikir vericek arkadaşlar

yardımcı olursa sevinirim.

Özellikleri şöyle:

• DLP projector Commercial DLP 1080P projectors to eliminate laser flare and laser aging issues.
• Stereolithography (SLA) printing technology: Bottom-up SLA configuration.
• Imported from USA (Sizes & Specifications are based on the USA Market).

Draken prints up to 8.66″ tall with up to 3.86″ x 7.09″ build

base at 90 micron XYZ resolution, one of the largest and tallest

among all personal SLA printers. Draken is one of the fastest

personal SLA printers in the market today. For other SLA printers

to print a 6.5 inch Statue of Liberty with 100 micron Z

resolution, it takes anywhere from 6 to 8 hours. With Draken, it

takes less than 4 hours. For most SLA printers on market, the

resin vat needs to be replaced every few months, because the

silicone coating on the vat might get cloudy after extensive

usage. In Draken, we bonded a thin Teflon layer on top of the

silicon coating, which greatly extended the lifetime of the vat.

You won’t need to worry about frequent replacement of the vat

anymore. 3DFacture Draken Features: Stereolithography (SLA)

printing technology: Bottom-up SLA configuration Sturdy print bed

with Teflon coating to dramatically reduce print bed clouding Use

of Commercial DLP 1080P projectors to eliminate laser flare and

laser aging issues Smart projector lens covering Novel Fast Peel

mechanism Universal projector mount adjustable to different types

of projectors Add on of Raspberry Pi for wireless print control

Support for 3rd party resins Printing Features: XY resolution:

37μm to 90μm Z resolution: 10μm Build Size: 7.1″ x 3.9″ x 8.7″ /

180mm x 98mm x 223mm Maximum print speed: > 3.6 inches / hr for

xy:50μm and z:100μm resolution > 1.8 inches / hr for xy:100μm and

z:100μm resolution